Massive Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: netdisc

Brocade 143-085 Brocade Certified Fabric Professional Gen 5 Exam Practice Test

Demo: 13 questions
Total 91 questions

Brocade Certified Fabric Professional Gen 5 Questions and Answers

Question 1

Referring to the exhibit, you see CRCs in the fabric and need to isolate the source.

Which porterrshow counter should you use?

Options:

A.

crc

B.

enc in

C.

bad eof

D.

crc g_eof

Question 2

The porterrshow command lists Class 3 frame discards increasing on some of the ISLs on a Brocade 6520. You need to identify the host that sent the frame and the storage to where the frame was being sent.

Which command would you use?

Options:

A.

framelog

B.

fabriclog

C.

portlogdump

D.

framerpathtest

Question 3

You are monitoring a flow using MAPS in Brocade Network Advisor.

Referring to the exhibit, which two flows would be imported into MAPS? (Choose two.)

Options:

A.

flow1

B.

flow2

C.

flow3

D.

flow4

Question 4

As a SAN administrator, you are asked to proactively monitor your fabric and fence ports when specified error conditions are met.

Which two features satisfy both these requirements? (Choose two.)

Options:

A.

Ingress Rate Limiting

B.

Fabric Watch

C.

Flow Vision

D.

Monitoring and Alerting Policy Suite (MAPS)

Question 5

Which feature is used when connecting a Brocade 6510 in Access Gateway mode to different fabrics while maintaining device-to-fabric consistency?

Options:

A.

Advanced Device Security

B.

port grouping

C.

failover

D.

port mapping

Question 6

Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

Options:

A.

Port 2 can be configured as an EX_Port.

B.

With proper configuration, ports 5 and 6 may be connected.

C.

With proper configuration, ports 1 and 2 may be connected.

D.

Port 1 may be configured as an EX_Port.

Question 7

Exhibit:

In the exhibit, if the master port goes offline, what will occur?

Options:

A.

The slave links will go offline.

B.

Frames on the slave links will be lost.

C.

The trunk group will split into multiple trunk groups.

D.

Frames on the master link will be lost.

Question 8

You need to allow for multiple NPIV logins to a single port on a Brocade 6520.

On which port must NPIV be configured?

Options:

A.

switch

B.

HBA

C.

device

D.

Access Gateway

Question 9

Your existing fabric has Brocade switches using Fabric OS v7.1 with Fabric Watch and Advanced Performance Monitor licenses already installed. You want to upgrade to v7.2 and run Flow Vision.

Which statement is true?

Options:

A.

You will need to install the Fabric Vision license in addition to the existing licenses on all switches in the fabric.

B.

You will need to install the Fabric Vision license only on the switches which are the source and destination for the flow.

C.

You do not need a Fabric Vision license on the switches.

D.

The existing Fabric Watch and Advanced Performance Monitor licenses on the switches will be deprecated after the upgrade.

Question 10

Your customer is replicating banking transaction data to a remote data center using Brocade 6510s and has a limited bandwidth of 32 Gbps. The transaction data should have priority over other data being replicated.

Which change meets this requirement?

Options:

A.

Configure compression on the trunk.

B.

Configure bottleneck detection on the trunk.

C.

Configure QoS on the trunk and use the setratelimit command for low priority traffic.

D.

Configure the QoS zone for the device transaction data to high priority.

Question 11

Your application is using an average frame size of 1024 bytes across your long-distance links.

Which two actions will fully saturate the link? (Choose two.)

Options:

A.

Set the port for LD and specify the distance.

B.

Set the port for LD and specify the frame size.

C.

Set the port for LS and specify the frame distance and size.

D.

Set the port for LE and specify the distance and frame size.

Question 12

Refer to the exhibit.

ISLs have been created from VE12 to VE16, and VE13 to VE17.

Referring to the exhibit, how many FCIP circuits have been created?

Options:

A.

2

B.

3

C.

4

D.

6

Question 13

Refer to the exhibit.

Referring to the exhibit, FC-FC routing has been properly configured. The ISL has failed.

Which statement is true?

Options:

A.

One of the IFLs will segment.

B.

FC-FC routing is not affected.

C.

New xlate domains will be created.

D.

A new FID will be dynamically created.

Demo: 13 questions
Total 91 questions